User manual

Installation and User Manual ADPRO FastTx by Xtralis
122 Doc 11949_06
Control outputs Model AFTX-10: 10 open collector outputs.
Model AFTX-20: 20 open collector outputs.
Screw terminal connectors.
12 Vdc (maximum), 100mA (maximum)
‘On state’ output voltage less than 1.1 V @ 100 mA.
General Alarm Relay output Form C, single pole changeover. Relay contact ratings: 1.0 amp, 32 volts.
Network Port 1x Ethernet 10BaseT / 100BaseT compatible supporting TCP/IP. RJ-45 connector.
Serial Communication Interface 2x V.24 asynchronous interfaces - 8 data bits, 1 stop bit, no parity, programmable
data rate steps from 9600 to 230400 bps. 1x 9 pin male D, 1x 25-pin male D.
Configured as a DTE device.
Supports Hayes (AT) compatible ISDN and PSTN modems in dial or leased line
configuration.
Support for Multilink PPP or V.120 data protocol over ISDN.
GP Serial Ports 2x General Purpose (GP) serial RS232 data ports for POS/ATM connection.
9 pin male D connectors. Configured as a DTE device. Maximum baud rate of
38,400 bps.
Programmable number of data bits (6, 7 or 8), stop bits (1 or 2), parity (odd, even,
none),).
Data (Transparent) Interface Bi-directional (transparent) RS232 serial data link between the Transmitter and
Receiver.
Configured as a DTE device.
Programmable baud rate from 1200, 2400, 4800, 9600, 19200, 38400, and 57600
bps.
Programmable number of data bits (7 or 8), stop bits (1 or 2), parity (odd, even,
none), flow control via handshaking (or Off).
9 pin male D connector.
I/O Interface 1x ‘Mode Select’ input pin. Programmable control of mode numbers assigned to pin
state.
1x ‘Access/Secure’ input for 3rd-party control of operational state. Open=Secure,
Ground=Access.
Available via 15-pin male D connector.
Audio Switch Interface Audio In/Out to VM22A or third party Audio Switcher.
Bi-directional audio sent simultaneously with the video (full duplex).
Bandwidth: 300 Hz to 3.3 kHz.
Input impedance: >6 k ohms. Input level: 10 mV to 400 mV RMS (nom)
Output impedance: >6 k ohm. Output level: 315 mV (nom)
Serial Output for Channel Number sequencing.
Open drain outputs (binary coded hex) indicating the currently selected channel.
32V maximum, 100 mA maximum, output impedance <0.5 ohm
Refer to VM22A Audio Switcher manual for details of serial protocol.
Function Description