User manual

Installation and User Manual ADPRO FastTx by Xtralis
96 Doc 11949_06
Figure 96: Event Input Settings
• The Type and Source selections are greyed out, enabling the operator to only change the
PTZ Preset Settings.
• Enter the appropriate settings and click OK.
Event Response
Once an Event has been declared, the Event Response settings are used to define the actions
that will be taken in response to the Event.
Figure 97: Event Response Tab
Activate Control Output
When checked, the control output correlating to the camera channel number currently being
programmed will be activated for a period as defined in the Alarm Input / Hold Time (refer to
Alarm Input Settings on page 81) upon full activation of an event. Refer to Control Outputs on
page 85.
Note: If the assigned Control Output number has been specified for Manual Operation,
then an error message will be displayed.