Specifications

7.9 Master Reset
Master reset, resets all the programming to factory default. Follow the steps to do a master
reset on RT-195 SW.
1 Under the main menu place the cursor in front of  Master Reset.
2 Press F.F button to accept that selection.
3 Master reset menu will pop up on the screen as shown the figure below.
4 Using the + or - buttons to place cursor in front of  Do Master Reset
5 Press the F.F button to master reset the RT-195 SW.
6 AVE Copy right menu will pop up on the screen notifying that VCR has been master
Rested.
5 Now place cursor in front of Calibrate and press F.F button.
6 A message will pop up on the screen stating Calibration in Progress. Press Stop
button to Finish.
7 Now drive the vehicle for about a mile.
8 RT-195 SW will calibrate the speedometer and assign a Calibrate value to that
vehicle.
9 Exit out from all the menus, RT-195 SW virtual speedometer has been calibrated.
Using the Calibrate Value to Calibrate Speedometer
Note: To enter the cal- Value, all the vehicle must have same make and model .
1 Under the speedometer menu place the cursor in front of Calibrate using + or -
buttons.
2 Press the F.F buttons to accept the above selection.
3 Enter the cal value obtain previously by using the +, -, REW or F.F buttons.
4 After entering the cal value press stop button.
5 Exit out of all the menus to activate above selection.
Display Speed on the Monitor
1 Under the speedometer menu place cursor in front of Speed display using + or  -
button.
2 Press F.F button to accept the selection.
3 Using + or - button use ON to display vehicle speed on monitor.
4 Press the F.F button again to accept the selection.
5 Exit out from all the menus to activate the selection.