Instruction manual

12
TDCT-Pro Time-Date-Character-Title
CNT7 Counter
CNT7 Counter accepts a TTL or 12VDC input active low to the RTS pin (7). To
reset the count via the front panel press the “Set” button. If the count exceeds
the maximum 7 digits it wraps around and continues counting from 0 again. If
you press “Set” button at any time the counter is reset to 0.
If CNT7 Counter is enabled and you use the title setting, the 7digit
count will be the first 7 characters on the title line and then the title will be
limited to only 13 characters.
CNT7 Counter can be programmed enable or disable by selecting an
enable as ON or an enable as OFF.The default will be OFF.
Figure 8: CNT7 COUNTER sub-menu
3. PROGRAMMING
Figure 7: ALARMING DISPLAY sub-main menu
Alarming Display
Alarming OSD to turn display on or off via RTS input. This will be a program-
mable selection that when True (RTS to Ground) turns full OSD display off and
when false (RTS Open) turns on.
Alarming Display can be programmed enable or disable by selecting an enable
as ON or an enable as OFF.The default will be OFF so always display charac-
ters.
Horizontal Position
To change the horizontal position of the inserted text on-screen, position the
arrow in front of “HORIZONTAL POS” and press “SET”. Press the “UP” or
“DOWN” buttons to move the text to the desired horizontal position.
ENABLE OFF
EXIT
ENABLE OFF
EXIT