Instruction manual

34
05/15/04 18:19:30
05/15/04 18:19:36
05/15/04 18:23:10
05/15/04 18:23:50
05/15/04 18:25:05
05/15/04 18:27:12
05/15/04 18:50:30
05/15/04 18:51:20
LOG
ON
OFF
ON
REC
STOP
V-LOSS
PLAY
STOP-P
This log shows the history of the operation
status in chronological order. What the
following entries represent is detailed below.
ON: Powers up the device.
OFF: Powers off the device.
REC: Starts recording.
STOP: Ceases recording
STOP-P: Ceases playback
PLAY: Shows recorded video.
V-IN: Video input is connected.
V-LOSS: Video loss occurs.
P-LOSS: Power interruption occurs.
A-IN: Detects an alarm input.
LOCK:
Disables the entire front panel
controls.
UNLOCK:
Releases the key lock.
UPDATE:
Updates system software.
Note: The log keeps an operation history on a
revolving basis because of a limit is 4000.
When the log is full, the newly registered
record of an operation will replace the
existing records from the oldest one.
MENU BACKGND:
There are
3 levels of background color
transparency, you can choose from: level 1 is
totally transparent, level 3 is opaque, and level
2 is between level 1 and 3. The background
color is used in setup menu and search
function.
BUZZER:
This option determines the embedded buzzer
sounding a tone to signal the following
situations. A tone lasts about two seconds
long.
ON: Enables buzzer.
OFF: Disables buzzer.
Situation
Alarm occurs
Video loss occurs
Disk is full
Load factory default
Buzzer set to ON
Enable/disable key lock function
Power on /off mobile rack HDD
Backup operation complete
Timer activate/deactivate
Recording switching between HDD
PASSWORD:
This option allows you to set a password to
prevent any unauthorized re-formatting of the
hard disk drives or use by the Viewer
Software. The standard password is “9999”.
OLD PASSWORD: Enter the pre-set
password (or the standard
password if this is the initial setting)
to access the password setting
system.
NEW PASSWORD: Enter a 4-digit-number
password of your choosing which
will replace the pre-set password
(or the standard password “9999”).
SETUP PWD:
When this option is on, user must pass the
password check before entering the setup
menu.
ON: Enables pass protection for setup menu.
OFF: Disables pass protection for setup
menu.