Instruction manual

66
5. PROGRAMMING
VSI-Pro Max POS / Cash Register Interface
DUMP MEMORY
You can upload any saved information from the VSI-Pro Max memory to any PC or some specific communication devices
using appropriate upload cable. To upload the information into a PC you must have any communication software which
can transfer the binary data. Press the “Up” or “Down” button to move the cursor to “DUMP MEMORY” and press “Set”.
The VSI-Pro Max will start uploading the data. The dumping memory process does not erase the internal saved memory
it merely sends out a copy. Therefore you can dump the data out as many times as you wish. However the memory will
be cleared if you save another data dump or connect to a register or run the demo mode, all of which overwrite the
memory buffer space.
REGISTER DEMO
This demonstration simulates transaction data from a register. This is used to demonstrate the VSI-Pro Max’s capabilities
with just a monitor and camera without having a register hooked up. When the demo mode is active the VSI-Pro Max
thinks the data is actually coming from a real register. You can use this demo data to configure exceptions and alarms
to be fully functional for a complete customer demonstration.
Press the “Up” or “Down” button to move the cursor to “REGISTER DEMO” and press “Set”. You will see the following;
Selecting “Characters 19 or 37” will give you two options of 19 or 37 characters per line.
Selecting “Type” will give you the choices of a demo from a Fast Food Resturant, Convenience Store, Grocery, Pizza
Shop, Coffee Shop or a Retail Store.
Selecting Speed per line will output each line at the programmed speed. The selections are 0.5s, 1s, 2s, 3s.
If you select “DEMO ON POWER UP” as “ON” then pressing the “Reset” or powering up or down will have no effect on the
demo mode and will continuously work until disabled by this menu selection. If you connect the VSI-Pro Max to a cash
register and it sends data to the VSI-Pro Max during this demo mode then the demo mode will also be disabled until you
press “Reset” or power down and up again.
Selecting “Start Demo” will exit the proramming mode immediately and start to display the data of the selected demo.
VERSION ID
When selected, this will display the version of software in use by the VSI-Pro Max shown detail (example below).
EXIT
Press the “Up” or “Down” button to move the cursor to “EXIT” and press “Set” to return to the previous menu.
VSI-Pro Max Version 14.00 R16
08/25/2011
CHARACTERS 19 or 37
TYPE FAST FOOD
SPEED PER LINE 0.5s
DEMO ON POWER UP OFF
START DEMO
EXIT
Figure 178: Register Demo Sub-Menu