Instruction manual

VSI-Pro Max POS / Cash Register Interface

5. PROGRAMMING

When you want to exit from the Programming Menu of a slave device, press the “Up” and “Down” and “Set” button at

the same time and will exit the menu of the slave. The “NETWORK PROGRAM” sub-menu will also appear on the

Master unit. Pressing “Reset” on the Master while remote programming slaves will result in resetting both the Master and

the Slave being addressed. If the Master unit losses power and stops communicating with the slave, the slave menu will

display until the communication handshaking time out expires and then will reset itself.

EXIT

Press the “Up” or “Down” button to move the cursor to “EXIT” and press “Set” to return to the “COMMUNICATION” sub

menu.

NETWORK MASTER RESET

The “Network Master Reset” selects and allows you to master reset the slave device.The Sub-Menu of Network Master

Reset can be accessed when the TYPE sub-menu in the NETWORK SETTING menu is set to MASTER.

To access the NETWORK MASTER RESET sub-menu, press the “Up” or “Down” button to move the cursor to “NET-

WORK MASTER RESET” and press “Set”. The following menu will appear:

ADDRESS ID

Choices: N/A,1,2,3,4,5,...,16, ALL

This selects the channel that want to master reset. To select the Address ID, press the “Up” or “Down” button to move the

cursor to “ADDRESS ID” and press “Set”. The cursor will start flashing. Then press the “Up” or “Down” button to cycle

through the values and press “Set” when the desired address is displayed.

Figure 154: Network Master Reset Sub-Menu

ADDRESS ID 1

DO MASTER RESET

EXIT

DO MASTER RESET

This selects to master reset the device that was selected from ADDRESS ID. To select the DO MASTER RESET, press

the “Up” or “Down” button to move the cursor to “DO MASTER RESET” and press “Set”.

If the ADDRESS ID sub-menu of Network Master Reset is set to address 1, 2, ..., 16. The DO MASTER RESET can

operate when the RS-485 network protocol of master identical with RS-485 network protocol of slave device that selected

from ADDRESS ID sub-menu.

DO MASTER RESET cannot change the TYPE, ADDRESS ID and RS-485 network protocol of any slave device. When

you want to change TYPE, ADDRESS ID and RS-485 network protocol of a slave device, you must use the OSD buttons

of the VSI-Pro Max or the PC Programming Software by connecting to the RS-232 Register port of each slave device

independently. This eliminates the user from accidently changing the network communication parameters causing the

slaves to stop communicating with the Master.

EXIT

Press the “Up” or “Down” button to move the cursor to “EXIT” and press “Set” to return to the “COMMUNICATION” Sub

Menu.