Instruction manual

17
5.2 MAIN PROGRAMMING MENU
Following is a detailed description of the menu selections and the programming capabilities of the VSI-Pro Max.
Figure 10 : VSI-Pro Max Main-Menu
5.3 REGISTER SELECT
To select a specific register, press the “Up” or “Down” button to move the cursor to “REGISTER SELECT“ and press
“Set”. The REGISTER SELECT menu will bring up a sub-menu consisting of registers shown in Figure 11. You can go to
the next or previous page by placing the cursor in front of “NEXT” or “PREVIOUS“ and then pressing “Set”. To select the
desired register, press the “Up” or “Down” button to move the cursor to that register and press “Set”. After selecting the
register, exit out of the REGISTER SELECT menu by pressing the “Up” or “Down” button to move the cursor to “EXIT” and
then pressing “Set”. In the main-menu, press “Reset” to activate the programing for that specific register. REGISTER
SELECT automatically formats the VSI-Pro Max to match your register’s communication settings. However, if you need
to change these settings, you can do so through the COMMUNICATION menu described later in this manual. Many
Register Selections have no submenu and are simply special filters that when selected are enabled. For these registers
no further explanation will be shown in this manual and the proper setups will be automatically loaded.
5. PROGRAMMING
VSI-Pro Max POS / Cash Register Interface
5.1 GETTING STARTED
To access the main-menu of the VSI-Pro, simultaneously hold down the “Down” & “Up” buttons
and wait 3 seconds and the main-menu will appear. An alternate method is to simultaneously hold down the “Down” &
“Up” buttons and press and release the “Reset” button and then after the main menu appears release the “Down” & “Up”
buttons. This will take you to the main programming menu. To navigate through this menu, simply use the “Down” and
“Up” buttons to position the cursor in front of the desired function, then press “Set” to access that function.
If you have difficulty entering the main-menu, try the following procedure exactly for sometimes difficult if the unit is not
easily accessed. With your left thumb, lightly press and hold in the two buttons to the left (Up & Down). While holding
down these buttons, press and release the “Set” button with your right thumb and continue holding the Up & Down
buttons until the main menu appears. Then release the Up & Down buttons.
NOTE



If a sub-menu has an “EXIT” selection, always go there and press "Set". Pressing "Reset" at the
main-menu exits you from the programming mode and may not save your selections.
REGISTER SELECT
SCREEN SETUP
TEXT DISPLAY
COMMUNICATION
EXCEPTION REPORT
ALARM OUTPUTS
TEST/DEMO MODE
DOWNLOAD/UPLOAD SETUP
MASTER RESET
HELP
NOTE



Whenever you select a register in this menu, certain programming features are reset to the default settings.
Always set the register selection first, get the data on-screen, then proceed with additional programming.