Instruction manual

VSI-Pro VIDEO SERIAL INTERFACE

NOTE





Any Programming or data transfer of any kind can overwrite the saved data in memory.

Figure 90: Register Demo Sub-Menu

EXIT

Press the “Up” or “Down” button to move the cursor to “EXIT” and press “Set” to return to the previous menu.

VERSION ID

When selected, this will display the version of software in use by the VSI-Pro shown detail (example below).

Figure 91: Characters 19 or 37 Sub-Menu

VSI-PRO Version 13.XXRXX

03/25/2008

DUMP MEMORY

You can upload any saved information from the VSI-Pro memory to any PC or some specific communication devices

using appropriate upload cable. To upload the information into a PC you must have any communication software which

can transfer the binary data. Press the “Up” or “Down” button to move the cursor to “DUMP MEMORY” and press “Set”.

The VSI-Pro will start uploading the data.

This demonstration simulates transaction data from a register. This is used to demonstrate the VSI-Pro’s capabilities

with just a monitor and camera without having a register hooked up. When the demo mode is active the VSI-Pro thinks

the data is actually coming from a real register. You can use this demo data to configure exceptions and alarms to be

fully functional for a complete customer demonstration.

Press the “Up” or “Down” button to move the cursor to “REGISTER DEMO” and press “Set”. You will see the following:

Selecting “CHARACTERS 19 OR 37” will give you two options of 19 or 37 characters per line. After selection the demo

will start after a few seconds. To exit this demo, press and release “Reset”. If data is sent to the VSI-Pro during this demo

mode with “DEMO ON POWER UP” set to OFF then the demo mode will be disabled and you must go back into the

programming mode and select again as described above.

Selecting “SPEED PER LINE” will show the demo for each line of a transaction in time interval that selected.

If you select “DEMO ON POWER UP” as “ON” then pressing the “Reset” or powering up or down will have no effect on the

demo mode and will continuously work until disabled by this menu selection. If you connec the VSI-Pro to a cash register

and it sends data to the VSI-Pro during this demo mode then the demo mode will also be disabled until you press “Reset”

or power down and up again.

Selecting “Start Demo” will exit the proramming mode immediately and start to display the data of the selected demo.

Press the “Up” or “Down” button to move the cursor to “CHARACTERS 19 OR 37” and press “Set”. You will see the

following:

DEMO 19 CHARACTER

DEMO 37 CHARACTER

CHARACTERS 19 OR 37

SPEED PER LINE 3 S

DEMO ON POWER UP OFF

START DEMO

EXIT

PROGRAMMING