Instruction manual

28
PROGRAMMING
VSI-Pro VIDEO SERIAL INTERFACE
TOLEDO
Version of the VSI-Pro that support: V13.00 and V13.10.
Press the “Up” or “Down” button to move the cursor to
“TOLEDO” and press “Set”. No menu will apprear and
merely sets the VSI-Pro to support the special protocol
of this model.
TEXAS DIGITAL
Version of the VSI-Pro that support: V13.00.
Press the “Up” or “Down” button to move the cursor to
“TEXAS DIGITAL” and press “Set”. No menu will apprear
and merely sets the VSI-Pro to support the special proto-
col of this model.
TEC SLIP PRINTER EMULATE
Version of the VSI-Pro that support: V13.10, V13.24 and
V13.34.
Press the “Up” or “Down” button to move the cursor to
“TEC SLIP PRINTER EMULATE” and press “Set”. The
TEC SLIP PRINTER EMULATE” menu will appear:
Figure 57: TEC SLIP PRINTER Sub-Menu
TKMAXX
Version of the VSI-Pro that support: V13.24 and V13.34.
Press the “Up” or “Down” button to move the cursor to
“TKMAXX” and press “Set”. The TKMAXX menu will ap-
pear:
Figure 58: TKMAXX Sub-Menu
MODEL: TEC SLIP PRINTER
MODE: EMULATING /TAPPING
EXIT
JOURNAL PRINTER
RECEIPT PRINTER
UNITOUCH DSP800
Version of the VSI-Pro that support: V13.00 and V13.10.
Press the “Up” or “Down” button to move the cursor to
“UNITOUCH DSP800” and press “Set”. No menu will
apprear and merely sets the VSI-Pro to support the spe-
cial protocol of this model.
UNIPAR
Version of the VSI-Pro that support: V13.24.
Press the “Up” or “Down” button to move the cursor to
“UNIPAR” and press “Set”. No menu will apprear and merely
sets the VSI-Pro to support the special protocol of this
model.
UNIWELL
Version of the VSI-Pro that support: V13.24 and V13.34.
Press the “Up” or “Down” button to move the cursor to
“UNIWELL” and press “Set”. No menu will apprear and
merely sets the VSI-Pro to support the special protocol
of this model.
UNIWELL UN4025
Version of the VSI-Pro that support: V13.00.
Press the “Up” or “Down” button to move the cursor to
“UNIWELL UN4025” and press “Set”. The UNIWELL UN
4025 menu will appear:
Figure 59: UNIWELL UN 4025 Sub-Menu
DEVICE ADDRESS
Choices: 000, 001, 002,..., 999
ANY ADDRESS
Choices: ON, OFF
DEVICE ADDRESS 000
ANY ADDRESS ON
EXIT
To save the device address configuration. Press and Re-
lease the “Up” & “Down” buttons simultaneously.