Instruction manual

25
VSI-Pro VIDEO SERIAL INTERFACE
Q-MATIC
Version of the VSI-Pro that support: V13.24.
Press the “Up” or “Down” button to move the cursor to “Q-
MATIC” and press “Set”. No menu will apprear and merely
sets the VSI-Pro to support the special protocol of this
model.
RADIENT
Version of the VSI-Pro that support: V13.00 and V13.10.
Press the “Up” or “Down” button to move the cursor to
“RADIENT” and press “Set”. No menu will apprear and
merely sets the VSI-Pro to support the special protocol
of this model.
RUBY SAPPHIRE
Version of the VSI-Pro that support: V13.00 and V13.10.
Press the “Up” or “Down” button to move the cursor to
“RUBY SAPPHIRE” and press “Set”. No menu will apprear
and merely sets the VSI-Pro to support the special proto-
col of this model.
SAMSUNG SRP350
Version of the VSI-Pro that support: V13.24 and V13.34.
Press the “Up” or “Down” button to move the cursor to
“SAMSUNG SRP350” and press “Set”. No menu will
apprear and merely sets the VSI-Pro to support the spe-
cial protocol of this model.
SCHEID U. BACH. DISPLAY
Version of the VSI-Pro that support: V13.24.
Press the “Up” or “Down” button to move the cursor to
“SCHEID U. BACH. DISPLAY” and press “Set”. No menu
will apprear and merely sets the VSI-Pro to support the
special protocol of this model.
Figure 46: SCHLUMBERGER Sub-Menu
SCHLUMBERGER
Version of the VSI-Pro that support: V13.24.
Press the “Up” or “Down” button to move the cursor to
“SCHLUMBERGER” and press “Set”. The
SCHLUMBERGER menu will appear:
DISPLAY
Choices: RECEIPT, CDU[ 2L ], C.D.U.
DISPLAY RECEIPT
EXIT
SENSORS
Version of the VSI-Pro that support: V13.00.
Press the “Up” or “Down” button to move the cursor to
“SENSORS” and press “Set”. The SENSORS menu will
appear:
Press the “Set” button again, The SENSORSOFT THER-
MOMETER menu will appear:
Figure 48: SENSORSOFT Sub-Menu
Figure 47: SENSORS Sub-Menu
DISPLAY
Choices: CELSIUS, FAHRENHEIT
SENSORSOFT THERMOMETER
MODEL: ST6105C
DISPLAY CELSIUS
EXIT
PROGRAMMING
PC COM 1, 2, 3, 4
Version of the VSI-Pro that support: V13.00 and V13.10.
Press the “Up” or “Down” button to move the cursor to
“PC COM 1,2,3,4” and press “Set”. No menu will apprear
and merely sets the VSI-Pro to “Generic” mode.
POLE DISPLAY
Version of the VSI-Pro that support: V13.34R1
Press the “Up” or “Down” button to move the cursor to
“POLE DISPLAY” and press “Set”. The POLE DISPLAY
menu will appear:
Figure 45A: POLE DISPLAY Sub-Menu
GENERIC
TOSHIBA