Instruction manual

23
VSI-Pro VIDEO SERIAL INTERFACE
NCR RCPT PRINTER
Version of the VSI-Pro that support: V13.24 and V13.34.
Press the “Up” or “Down” button to move the cursor to
“NCR RCPT PRINTER” and press “Set”. No menu will
apprear and merely sets the VSI-Pro to support the spe-
cial protocol of this model.
NCR7454WS/7197
Version of the VSI-Pro that support: V13.00 and V13.10.
Press the “Up” or “Down” button to move the cursor to
“NCR7454WS/7197” and press “Set”. No menu will apprear
and merely sets the VSI-Pro to support the special proto-
col of this model.
NCR7456
Version of the VSI-Pro that support: V13.00 and V13.10.
Press the “Up” or “Down” button to move the cursor to
“NCR7456” and press “Set”. No menu will apprear and
merely sets the VSI-Pro to support the special protocol
of this model.
NCR
Version of the VSI-Pro that support: V13.00 and V13.10.
Press the “Up” or “Down” button to move the cursor to
“NCR” and press “Set”. The NCR menu will appear:
Figure 37: NCR Sub-Menu
NIXDORF BEETLE
Version of the VSI-Pro that support: V13.00 and V13.10.
Press the “Up” or “Down” button to move the cursor to
“NIXDORF BEETLE” and press “Set”. The NIXDORF
BEETLE menu will appear:
Figure 39: NIXDORF BEETLE Sub-Menu
Figure 40: NORAND 1200 Sub-Menu
TITLE DISPLAY
Choices: ON, OFF
CONSOLE ID
Choices: ANY, 1, 2, 3, 4, 5, 6, 7, 8
WORKING MODE
Choices: ACK , TAP
NORAND 1200
Version of the VSI-Pro that support: V13.00.
Press the “Up” or “Down” button to move the cursor to
“NORAND 1200” and press “Set”. The NORAND 1200
menu will appear:
NCR 2113,3110
NCR 745X [ POLE ]
NCR JRNL PRINTER
NCR RCPT PRINTER
NCR SLIP PRINTER
TITLE DISPLAY : ON
CONSOLE ID : ANY
WORKING MODE : TAP
EXIT
Figure 38: NIXDORF BEETLE Sub-Menu
NIXDORF BEETLE
Version of the VSI-Pro that support: V13.24 and V13.34.
Press the “Up” or “Down” button to move the cursor to
“NIXDORF BEETLE” and press “Set”. The NIXDORF
BEETLE menu will appear:
JOURNAL PRINTER
RECEIPT PRINTER
REMOTE SLIP
OPERATOR DISPLAY
PROGRAMMING
Note: When you select the MICROS IDN NETWORK Sub-
Menu and select the DEVICE sub-menu as PRINTER,
and the MODE sub-menu set as EMULATE, the DEVICE
ADDRESS must be identical with the address of Printer.
You must replace the RS-232 chip (U5) on VSI-Pro PCB
with MICROMOD485 Adapter and connect the 021-188-
SF cable between Printer ( Micros Adapter ) and DB9
Male of VSI-Pro.