Specifications

T: 713-686-8409 | F: 713-686-8509 | www.aveusa.com | [e-mail]
49
Control Products
VECA
Video Enhancer Compensator Amplifier
The VECA is an inline device to compensate for video degradation due to long cables. There are two controls on the
VECA, one for enhancing and the other for gain.
Installation
Connect the VECA in line with the video signal you wish to enhance. Adjust the gain so the over all video level at the
monitoring end is returned to 1V P-P. Then turn on the Enhance switch and adjust clockwise until the picture is improved to
your satisfaction.
Gain
This control amplifies or attenuates the overall gain or video level of the signal. This can recover attenuated signals due
to long cable runs up to X2 video gain. It can also attenuate the video gain if the video is too high or you up enhance to
maximum.
Enhance
This control improves the video picture to get high quality by rectifying the picture contour. Move the control clockwise to
increase the high frequency component of the video signal to enhance the picture. Turning the control all the way counter
clockwise will attenuate the high frequency portion of the video for a soft look.
Enhance On/Off
If this switch is in the “Off” position the enhancement circuitry is turned off and the adjustment control makes no difference.
In this position the user can adjust the proper overall video level. In the “On” Position the enhancement is enabled and one
can adjust for optimum enhancement.
Default Factory Adjustment
The factory presets the Gain at unity X1 which is no amplification or attenuation. The enhancement adjustment is nominal
and unity or X1 enhancement. The enhance switch is in the “Off” Position.
Power
The VECA uses a standard 2.1mm x 5.5mm DC Coax Plug for power. 12VDC @ 100ma is required.
A B
o
r
A
mp
lifi
e
r