Service manual

Installation: Installing Base Station/Repeater Hardware Options 2-31
- Wireline Squelch Level
- Wireline Receive Level
- Wireline Rx Equalization
4. Performing post-optimization procedures.
5. Writing the customized codeplug to the base station/repeater codeplug.
For details on these tasks, refer to the Customer Programming Software (CPS) Online Help.
2.5.2 Copying Base Station/Repeater Codeplug Date To a PC-compatible Computer
2.6 Installing Base Station/Repeater Hardware Options
When a base station/repeater is ordered with an Antenna Relay or External Preselector option, the
respective module is attached to the base station/repeater when delivered.
When a base station/repeater is ordered with an External Double Circulator option, this circulator is
provided in a peripheral tray.
In the case where an option is later added to the base station/repeater, it can be installed according
to the information provided in the Ancillary Equipment sections of the appropriate Instruction manual.
Also refer to the Troubleshooting section for information on tuning the External Preselector.
A minimum of a 10-minute warm up period prior to aligning the station reference
is required with the 800/900 MHz base station/repeater. Failure to comply will
result in an inaccurate reference frequency alignment.
A copy of each base station/repeater’s codeplug data must be made on an IBM-
PC compatible computer. This is done through the Customer Programming
Software (CPS).
W A R N I N G
C a u t i o n