Service manual

2-30 Installation: Optimization
NOTE: The RDAC application will be needed when the Status LED is red (solid or flashing). This
status indicates a minor or major alarm. The RDAC application is used to identify the specific
alarm and probable diagnosis to aid in identifying the FRU at fault.
If the Reference LED remains amber for more than ten minutes during the alignment, then
verify the integrity of the source used to train the base station/repeater’s internal reference. If
the integrity of the source is verified to be good, then the SCM will need to be replaced.
2.4.2.2 Exercising Radio Operation
This may be carried out when an external speaker and microphone are connected to the SCM.
The kit number for the speaker is HSN1006. The external speaker requires an adaptor cable with the
part number 0185180U01.
The kit number for the noise-cancelling microphone is GMMN4063 or older GMN6147.
2.5 Optimization
After the base station/repeater and ancillary equipment have been mechanically installed, properly
cabled, and power applied, the equipment must then be optimized; that is, before placing the base
station/repeater in operation. Optimizing is performed through the Customer Programming Software
(CPS) with the kit number, RVN5115 and a USB cable (NAG: CLN8665A, EMEA: DDN9957) is
required.
After the base station/repeater is operational, the base station/repeater’s codeplug data must be
copied to a PC-compatible computer.
2.5.1 Optimizing Tasks
Optimization involves the following tasks:
1. Reading the base station/repeater codeplug from the base station/repeater (this ensures a
match between the base station/repeater serial number (resident in the codeplug) and the
serial number (part of the customized base station/repeater codeplug data) that is written
back to the base station/repeater (see task 5).
2. Customizing the base station/repeater codeplug and saving the data to the base station/
repeater.
3. Aligning the base station/repeater for:
- Modulation Limit
- Speaker Level
- Station Reference
- MTR2000 PA Calibration
- Receiver Squelch Adjust
- Wireline Transmit Level
Using a speaker other than the recommended HSN1006 or older HSN1000 may
result in the station blowing a fuse.
C a u t i o n