Service manual

2-28 Installation: Post Installation Checklist
2.4.2.1 Front Bezel LEDs
After booting up the base station/repeater, the six LEDs (Power/Status, Tx Slot 1, Tx Slot 2, Rx Slot
1, Rx Slot 2 and the Mode LEDs) flashes in unison.
The general status and condition of the MTR3000 Base Station/Repeater can be obtained by
observing the eight LED indicators on the front bezel. Table 2-10 shows the LED symbols and their
meaning while Table 2-11 identifies the information conveyed via the LED indicators.
Table 2-10. Front Bezel LED indicators
LED Definition
Status
Tx Slot 1 (for label number 1)
Tx Slot 2 (for label number 2)
Rx Slot 1 (for label number 1)
Rx Slot 2 (for label number 2)
Mode
Ethernet Link
Reference