Service manual

Installation: Mechanical Installation 2-15
2.2.2.6 Installing Slide Rail Assembly in a Non-Motorola Cabinet
Referring to Figure 2-8, perform the following procedure to install non-Motorola slide rail.
On a bench-top, working on one side of the slide rail assembly at a time:
1. Remove the Inner-Slide Rail from the slide assembly (left and right) by depressing the Slide
Locking Latch and sliding the Inner-Slide Rail out from the slide assembly.
2. Install the Inner-Slide Rail (left) on the Power Supply side by:
- removing the two bottom screws from the base station/repeater power supply EMI cover,
and
- installing the Inner-Slide Rail (left) with the supplied screws.
3. Install the Inner-Slide Rail (right) on the PA side using the holes in the PA casing.
4. Attach each Outer-Slide Rail to the cabinet Brackets with supplied screws. Only use the lower
slot of each bracket. Leave the screws loose; they will tightened when the brackets are
mounted in the cabinet (in step 7).
NOTE: The left and right Cabinet Bracket sets are identical.
The Locking Tab of each Outer-Slide Rail must face towards the rear of the cabinet.
Working in the cabinet:
5. Install a cage nut in line with clearance hole in Threaded Strip prior to fitting the Front Bracket
to the front cabinet rail. This nut is required for mounting the base station/repeater (in step 9).
The cage nuts are provided with the cabinet.
6. Fit the Short Bracket and Long Bracket (with attached Outer-Slide Rail) to the Front and Rear
Cabinet Rails using the Bracket Mounting Screws and Threaded Strips.
7. Tighten the Outer-Slide Rail hardware after positioning the Outer-Slide Rail front side in line
with the inner surface of the Front Cabinet Rails.
8. Slide the base station/repeater (with an Inner-Slide Rails mounted on each side) into the
Outer-Slide Rails in the cabinet; an audible snap is heard. Continue sliding the base station/
repeater in until the base station/repeater is fully seated.
9. Secure the base station/repeater to the Front Cabinet Rails with the supplied Base Station/
Repeater Mounting Screws.