Service manual

Installation: Mechanical Installation 2-11
4. Remove antistatic bag. Do not discard bag, it will be reinstalled to protect equipment during
installation (see Figure 2-5).
Figure 2-5 Remove Antistatic Bag
5. Depending on cabinet type, either open or remove front and rear doors to gain access to the
four (4) bolts securing the floor-mount cabinet to the wooden skid. Remove the bolts and nuts
as shown (see Figure 2-6).
Figure 2-6 Remove Bolts and Nuts
6. Use hoist to lift the floor-mount cabinet from the skid. Remove skid and return floor-mount
cabinet to floor.
7. Replace antistatic bag over base station/repeater (if desired) to provide protection during
installation.
Antistatic Bag
Wooden
Skid
Station
Cabinet