Installation guide

Using Remote Software

Setup Requirements:

• Network connection to PC.

• IP address of your

Full-Featured MPEG-4 series DVR. To check the DVR’s IP address, press

MENU key on the unit and enter password to access OSD Main menu; select <System Setup>,

<Network Setup>, then <LAN Setup> to check the IP.

Changing Internet Setting:

• Start the IE; select <Tools> from the main menu of the browser, then <Internet Options> and

then click the <Security> tab.

• Select <Trusted sites> and click <Sites> to specify its security setting.

• Disable Require server verification (https:) for all sites in this zone. Type the IP address of the

unit in field and click <Add> to add this website to the zone.

• In the Security Level area, click <Custom Level>. Under <All ActiveX controls and plug-ins>,

set all items to <Enable> or <Prompt>.

• Click <OK> to accept the settings and close the <Security> screen.

Using the Remote Software:

• Start the IE and enter the IP address of your Full-Featured MPEG-4 series DVR in the address

field.

• The ActiveX controls and plug-ins dialog will show twice for confirmation, click <YES> to accept

ActiveX plug-ins. The DVRRemote plug-ins will be downloaded and installed on your PC

automatically when the connection is successfully made.

NOTE: Do not enter any leading 0 characters in the address, for example,

“192.068.080.006” should be entered “192.68.80.6”.

NOTE: If the default trigger port 80 is changed into another one, port 81 for example, you

should enter the IP address as “192.68.80.6:81”.

• Version verification starts automatically to verify whether DVTRemote was installed. This

process may take up to 30 seconds.

• When the software is completely downloaded, the Login Screen is displayed.

• Enter your username and password. The default usernames and passwords are admin: 1234,

user: 4321.