User Guide

“HOME” to cameras four and/or eight on an alarm. Homing to cameras four
and eight will occur on an alarm regardless of the switch positions of the
other cameras. If cameras four and/or eight are in the bypass mode, it will
still home upon an alarm and return to the sequence or other selected modes
upon the completion of the alarm. If cameras 1, 2, and 3 or 5, 6, and 7 are
sequencing, and cameras 4 and/or 8 are in the bypass mode, upon an alarm
the switcher will home to camera 4 and/or 8 for the alarm duration; then,
when the alarm stops, it will continue the sequence from where it was when
the alarm was triggered.
NOTE: Upon powering up the 8PSWT, the switcher waits one dwell
time to initialize. This may take from 1 second to 1 minute depending
on the present dwell time setting.
POWER
The switcher is powered by the included wall transformer. The unit can be
powered from 9 to 12VDC. The center post of the DC Coax is POSITIVE.
CONNECTIONS
The VIDEO inputs are BNC type connectors. The inputs are 75 ohm
terminated and require 1V P-P. The output is 1V P-P and will drive a 75
ohm load. Connect the video cameras to the switcher in the desired order.
Connect Video out to your VCR or Monitor. Plug in the DC Coax connector.
The switcher is now operational. Select the desired front panel controls and
adjust the dwell.
4
_____________________________________________
Internal Jumper Settings:
JP2=open JP3=shorted