User manual

87
Version 2.4 (10/2011) en
Original instructions
Drum Motor
Installation
Warning notices concerning installation
¾ Do not drop or mishandle the Drum Motor to prevent internal damage.
¾ Check each Drum Motor for damage before installation.
¾ Do not hold, carry or support the Drum Motor by the cables or wires extending
out of the mounting shaft to prevent damage to the internal solder joints and
sealings.
¾ Do not twist the motor cable.
¾ Do not overtension the belt.
Mounting the Drum Motor
Positioning the Drum Motor ¾ Ensure that the data label information is correct and meets the specification
that has been ordered and confirmed.
Rotating parts and accidental motor start-ups
Risk of pinched fingers
¾ Do not insert fingers between the Drum Motor and any
sort of belt or roller chain.
¾ Install a protection device (such as a guard plate) to
prevent fingers from getting trapped in any sort of belt
or roller chain.
¾ Attach an appropriate warning notice on the conveyor.
Risk of damage leading to failure or shortened life
expectancy of the Drum Motor
¾ Observe the following notices.
CAUTION
Hint
For non-horizontal Drum Motor applications a special design is required. The
design must be specified at time of order.
Contact Interroll if in doubt.
Hint
The Drum Motor has to be mounted horizontally within +/- 5° (Drum Motor 113s:
+/- 2°) unless otherwise indicated in the order confirmation.
Drum Motor position
-2°
-5°
+2°
+5°