User manual

86
Version 2.4 (10/2011) en
Original instructions
Drum Motor
Transport and storage
Transport
¾ Check each Drum Motor for damage after transport.
¾ In case of damage, take photos of the damaged parts.
¾ Report any damage caused by transport immediately to the transport
company and Interroll, to maintain warranty.
Storage
¾ Store the Drum Motor in a clean, dry and enclosed area between +15 and
+30 °C and protect it from wet and damp.
¾ For storage periods of more than three months rotate the shaft periodically to
prevent deterioration of the shaft seals.
¾ Check each Drum Motor for damage after storage.
Risk of injury due to improper transport
¾ Transport may only be carried out by qualified and
authorized persons.
¾ For Drum Motors with diameters of 136 mm or above
use a lifting rope or harness during transport. The
working load capability of the lifting rope or harness
must exceed the weight of the Drum Motor. They also
must be securely attached onto the shafts when lifting.
¾ Do not stack pallets.
¾ Make sure that the Drum Motor is fixed properly before
transport.
Risk of damages to the Drum Motor due to improper
transport
¾ Avoid hard shocks during transport.
¾ Do not lift the Drum Motor by the cable or Terminal Box.
¾ Do not transfer the Drum Motors between warm and
cold environments. This may cause water
condensation.
¾ Ensure that the S-series Drum Motors which are
manufactured for vertical mounting are transported in
horizontal position.
CAUTION
Risk of injury due to improper storage
¾ Do not stack pallets.
¾ Do not stack more than four carton boxes.
¾ Ensure proper fixing.
CAUTION