User's Manual

- 0 – indicates that the refresher is omitted
- 1– indicates that the refresher is configured to
UAC
- 2– indicates that the refresher is configured to
UAS
SET_RESP_REFRESHER [x]
This parameter indicates what refresher value is
configured in the 200 OK response. The values are
0, 1, and 2. The default value is 2.
- 0– indicates that the refresher is omitted (only
valid when SET_REQ_REFRESHER is not equal
to 0)
- 1– indicates that the refresher is configured to
UAS
- 2– indicates that the refresher is configured to
UAC
PORT_MIRROR_ENABLE [YES| NO] This parameter enables or disables the Port
Mirroring feature. The default value is NO.
- YES – the Port Mirroring prompt in the Advanced
Diag Tools dialog is enabled and can be
modified.
- NO – the Port Mirroring prompt in the Advanced
Diag Tools dialog is disabled (dimmed) and cannot
be modified.
MEMCHECK_PERIOD [seconds]
This parameter determines the time period in
seconds when the Memory monitor wakes up (after
re-start or the last memory check attempt). The
values are 1800 (0.5 hrs) to 86400 (24 hrs). The
default value is 86400 (24 hrs).
DOS_PACKET_RATE [pps]
This parameter determines the maximum number
of packets per second that is allowed.
DOS_MAX_LIMIT [pps] This parameter specifies how many packets past
the DOS_PACKET_RATE the IP Deskphone can
receive before packets are dropped. If packets are
received at a rate of DOS_PACKET_RATE +1, then
packets are dropped after the time specified in
DOS_MAX_LIMIT (in seconds).
DOS_LOCK_TIME [seconds]
This parameter specifies the amount of time (in
seconds) that the IP Deskphone stops processing
packets after DOS_MAX_LIMIT is reached. If
Feature configuration commands
SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012 87