User's Manual

- EU2
- AusNZ
The default value is NA.
HOTLINE_ENABLE [YES | NO]
This parameter indicates if Hotline Service is
enabled or disabled. The default value is NO.
- YES – enables Hotline Service
- NO – disables Hotline Service (default).
Note:
If a service package is enabled then this value is
overridden by the value in the service package.
HOTLINE_URL
This parameter is used as To field of INVITE
message by the SIP IP Deskphone to notify the
Proxy Server that this is a call from a Hotline Phone.
The HOTLINE_URL is not a real URL of the Hotline
target. The IP Deskphone has no idea about the
Hotline target. The Proxy server replaces the To
field of INVITE request message with a real Hotline
target when it receives an INVITE request from the
Hotline Phone. The default value is Hotline.
SESSION_TIMER_ENABLE [YES |
NO]
This parameter indicates if the session timer service
is enabled or disabled. The default value is YES.
- YES – the Session Timer Service for the IP
Deskphone is enabled, and the behavior of the IP
Deskphone complies with RFC4028.
- NO – the Session Timer Service is disabled.
SESSION_TIMER_DEFAULT_SE
[seconds]
This parameter indicates the default session
expiration in seconds. The Session-Expires header,
in a request, informs the terminating endpoint and
proxies of the Session-Expires interval value that
the originating endpoint requires for the session
timer duration, in units of delta seconds. The default
value is 1800.
SESSION_TIMER_MIN_SE [seconds]
This parameter indicates the minimum session
expiration in seconds. The default value is 1800.
SET_REQ_REFRESHER [x] This parameter indicates what refresher value is
configured in the initial session request. The values
are 0, 1, and 2. The default value is 0.
Configure the provisioning server
86 SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012
Comments? [e-mail]