User's Manual

timeout interval and keeps the timeout value of 64
seconds.
- minimum value is 4 seconds
- maximum value is 10 seconds
If the value defined in the System Configuration file is
incorrect, the default value is used.
DHCP_UNTAG_ENABLED [YES |
NO]
When this parameter is enabled, the IP Deskphone
attempts to obtain an IP address in a VLAN (DHCP
discovery frames are tagged), and the DHCP server is
unreachable, then after the pre-defined number of
Discovery attempts the IP Deskphone begins sending
Discovery frames in non-VLAN mode. If the IP
Deskphone still does not receive an Offer then, after a
pre-defined number of Discovery attempts, the IP
Deskphone reverts to VLAN tag mode again.
The default is NO.
HTTP_RETRY_NUMBER
This parameter configures the number of times the IP
Deskphone attempts to contact the server when an
HTTP 503 (server is unavailable) response is received.
The IP Deskphone stops trying to connect to the server
after HTTP_RETRY_NUMBER unsuccessful attempts
have been made, or if any other response except HTTP
503 is received from the server.
x = positive integer. The default value is 5.
If HTTP_RETRY_NUMBER is not specified in the Device
Configuration file, the default number of attempts is
applied.
If HTTP_RETRY_NUMBER is set to 0 in the Device
Configuration file, the IP Deskphone performs HTTP
retries continuously until it receives a response other
than HTTP 503. If the HTTP_RETRY_NUMBER is
configured as a negative value, the default number of
attempts is applied.
Configure the provisioning server
56 SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012
Comments? [e-mail]