User's Manual

If the IP Deskphone is behind a firewall, it is very likely
that you must keep SIP_PING enabled, unless an
alternate method of keeping the firewall pinhole open is
used.
The default value is YES if not specified in the device
configuration file. If SIP_PING is changed in the Device
configuration file, the IP Deskphone must be rebooted for
the change to take effect.
- YES – enables pinging
- NO – disables pinging
REG_REFRESH_INTERVAL
[seconds]
This parameter allows the administrator to change the
default re-registration time of the IP Deskphone. The
default is 86400 seconds (or 24 hours). The minimum
value is 300 and the maximum value is 86400. Note that
the proxy can override this value and force the IP
Deskphone to have a different refresh interval.
IPV6_ENABLE [YES] [NO]
This parameter must be applied at boot time prior to the
network being enabled. The default value is NO. When
this parameter is enabled, IPv4/IPv6 are supported on
the IP Deskphone. When this parameter is not enabled
only IPv4 is supported on the IP Deskphone.
- YES – enables IPv6 functionality in a dual mode
- NO – disables IPv6 functionality (default)
When the protocol is changed, the IP Deskphone
automatically restarts and updates the Device Settings
on the IP Deskphone.
PREFER_IPV6 [YES] | NO] This parameter allows the administrator to select the
source address from the set of IPv4/IPv6 addresses. In
a dual mode, by default all IP Deskphones prefer IPv4
addresses. The default value is NO. When
PREFER_IPV6 is configured to YE,S the IP Deskphone
selects the IPv6 address when there is a choice between
IPv4 and IPv6 addresses.
- YES –IPv6 address is selected.
- NO –IPv4 address is selected.
IPV6_STATELESS [YES | NO]
This parameter configures stateless autoconfiguration. If
IPV6_STATELESS parameter is configured to [YES],
then autoconfiguration is enabled. The default value is
YES. If this parameter is configured to [NO], then
addresses must be configured through manual or static
configuration.
Configure the provisioning server
50 SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012
Comments? [e-mail]