User's Manual

Modify the SIP provisioning file
Use the following procedure to modify the SIP provisioning file, which exists on the provisioning
server.
Modifying the SIP provisioning file
1. Under the firmware [FW] section of the SIP Provisioning file, increase the VERSION
number (for example SIP1165e03.02.16.00).
2. Under the firmware [FW] section of the SIP Provisioning file, modify the FILENAME
of the new file you want to upload to the IP Deskphone.
Important:
The VERSION number must be the same as the FILENAME (do not include
the .bin extension).
For example, if the FILENAME is SIP1140e03.00.33.04.bin, then the VERSION
must be SIP1140e03.00.33.04.
3. Invoke the upgrade mechanism.
Use one of the next three methods to invoke a software upgrade on the
IP Deskphone with SIP Software.
a. Power off and power on the IP Deskphone.
b. Select Services > Check For Updates on the IP Deskphone.
c. Allow for an automatic check for updates to occur. (See AUTO_UPDATE
under
Feature configuration commands on page 57).
Any of these actions causes the IP Deskphone to contact the provisioning server
and attempt to read the Provisioning file. A Soft Reset (Srvcs > System > Reset
Phone) does not cause the IP Deskphone to retrieve the Provisioning file and
therefore does not cause a software upgrade.
Upgrade to the minimum UNIStim Software
The IP Deskphone can be ordered with UNIStim software installed or with SIP Software
installed. You can convert the software on an IP Deskphone from UNIStim to SIP. To
successfully convert the software from UNIStim to SIP, the UNIStim software version on your
IP Deskphone must be 0625C39 or higher.
Upgrade and convert the IP Deskphone software
116 SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012
Comments? [e-mail]