User's Manual

Note:
To provision AUTOLOGIN_ID_KEY[xx]
[userID@domain name], the IP Deskphone must be
rebooted after the IP Deskphone configuration file is
updated.
AUTOLOGIN_PASSWD_KEY [xx]
This parameter is located within the IP Deskphone-
specific configuration file. There is no default password.
If this is blank and AUTOLOGIN_ENABLE is configured
to USE_AUTOLOGIN_ID in the device configuration
file, the IP Deskphone does not log on.
Note:
To provision AUTOLOGIN_PASSWD_KEY [xx], the
IP Deskphone must be rebooted after the
IP Deskphone configuration file is updated.
PROMPT_AUTHNAME_ENABLE
[YES | NO]
This parameter causes the user to be prompted to enter
an authentication name when they log on to the IP
Deskphone. For CS 1000, it is necessary to configure
an authentication name when configuring IP Deskphone
features.
- YES – prompt the user to enter an authentication
name.
- NO – authentication name is not configured.
AUTOLOGIN_AUTHID_KEY [xx]
This parameter specifies the authentication name to be
used for a specific key.
•
Create the Dialing Plan file on the provisioning server
If the IP Deskphone encounters a [DIALING_PLAN] section while parsing the 11xxeSIP.cfg
configuration file, the IP Deskphone downloads the specified dialing plan configuration file.
A dialing plan essentially describes the number and pattern of digits that a user dials to reach
a particular telephone number. Access codes, area codes, specialized codes, and
combinations of the number of digits dialed are all part of a dialing plan.
The purpose of the dialing plan is so that the end user does not have to press the send or
pound key (#) to have the IP Deskphone with SIP Software send the initial message to start
the call.
Dialing a telephone number on an IP Deskphone that supports SIP can be different than dialing
a number from a traditional telephone. SIP signaling is communicated through a SIP URI to
Configure the provisioning server
102 SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012
Comments? [e-mail]