User's Manual

DELAY_EXCE [xx] This parameter is the threshold to report unacceptable
Excessive Delay greater than [xx]. The default is 175 ms.
Using 0 resets the threshold to default.
- xx – is an INTEGER value used as a threshold measured in
1/1000 of a second.
SESSION_RPT_EN [YES |
NO]
This parameter enables or disables periodic VQMon session
reports. The default is disabled.
Both session report enable and session report interval must
be configured if the IP Deskphone software has been
upgraded to SIP Release 3.0 or later. Otherwise, the
SESSION_RPT_INT default of 60 seconds is used
automatically. The default value is NO.
- YES – enables periodic VQMon session reports.
- NO – disables periodic VQMon session reports.
SESSION_RPT_INT [xx]
This parameter specifies the interval for the periodic VQMon
session report in seconds. The minimum acceptable value is
60 seconds. The maximum acceptable value is 600 seconds.
The default is 60 seconds.
- xx – is an INTEGER value in seconds.
System commands
ADMIN_PASSWORD [password] This parameter changes the default administrator
password of the IP Deskphone that is used for
unlocking network menus. The default is 26567*738.
- password – the administrator password
ADMIN_PASSWORD_EXPIRY
[seconds]
This parameter configures the date when the
ADMIN_PWD is no longer valid and requires a new
password to be downloaded from the provisioning
server.
HASHED_ADMIN_PASSWORD
[YES | NO]
This parameter indicates whether the Admin password
is hashed or not. The default value is NO.
- YES – Admin password is hashed.
- NO – Admin password is not hashed.
Configure the provisioning server
100 SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012
Comments? [e-mail]