User's Manual

Note:
To provision AUTOLOGIN_PASSWD_KEY [xx], the
IP Deskphone must be rebooted after the
IP Deskphone configuration file is updated.
PROMPT_AUTHNAME_ENABLE
[YES | NO]
This parameter causes the user to be prompted to enter
an authentication name when they log on to the IP
Deskphone. For CS 1000, it is necessary to configure
an authentication name when configuring IP Deskphone
features.
- YES – prompt the user to enter an authentication
name.
- NO – authentication name is not configured.
AUTOLOGIN_AUTHID_KEY [xx] This parameter specifies the authentication name to be
used for a specific key.
•
Create the Dialing Plan file on the provisioning server
If the IP
Deskphone encounters a [DIALING_PLAN] section while parsing the 11xxeSIP.cfg
configuration file, the IP Deskphone downloads the specified dialing plan configuration file.
A dialing plan essentially describes the number and pattern of digits that a user dials to reach
a particular telephone number. Access codes, area codes, specialized codes, and
combinations of the number of digits dialed are all part of a dialing plan.
The purpose of the dialing plan is so that the end user does not have to press the send or
pound key (#) to have the IP Deskphone with SIP Software send the initial message to start
the call.
Dialing a telephone number on an IP Deskphone that supports SIP can be different than dialing
a number from a traditional telephone. SIP signaling is communicated through a SIP URI to
get to the far end. For example, you can key in the SIP address, [e-mail] to
reach John Smith. When the IP Deskphone with SIP Software receives this address, the dialing
plan is bypassed and the IP Deskphone uses the SIP URI to send a SIP INVITE to
[e-mail] (INVITE sip: [e-mail]).
Entering a SIP URI address, however, is inconvenient for an IP Deskphone with SIP Software
unless a USB keyboard is attached. Also, the user must explicitly press the send key (or use
some method to indicate the end of the URI) to indicate the completion of the SIP address.
This is not something that the user is accustomed to in a traditional PBX environment.
The alternative is to use a URI where numbers are used to reach the far end. Using different
access codes, the IP Deskphone with SIP Software translates the digits entered into something
that the server can understand and remaps the number entered into different URIs. Some of
Create the Dialing Plan file on the provisioning server
SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012 93