User's Manual

Default is 255, which is equivalent to the recovery level of 2.
LOG_LEVEL [x] This parameter defines which IP Deskphone bugs are logged in the
ECR file. The following values are used for configuring the logging
level on the IP Deskphone.
x - level of bugs from 0 to 255. The default value is 2.
- 0 - logging is blocked
- 1 - log only Critical bugs
- 2 - log Critical / Major bugs
- 3 - log Critical / Major / Minor bugs
- if > =4 – log all information and bugs
IP Deskphone configuration commands summary
AUTOLOGIN_ID_KEY[xx]
[userID@domain name]
This parameter is located within the IP Deskphone-
specific configuration file. This is the ID the
IP Deskphone uses to register. The default user ID is the
MAC ID of the IP Deskphone.
- xx – xx = 00 to the maximum number of keys
supported on the IP Deskphone
- userID@domain name – the user ID must be followed
by the domain name; example,
[e-mail]; example,
[e-mail]
Note:
To provision AUTOLOGIN_ID_KEY[xx]
[userID@domain name], the IP Deskphone must be
rebooted after the IP Deskphone configuration file is
updated.
AUTOLOGIN_PASSWD_KEY [xx] This parameter is located within the IP Deskphone-
specific configuration file.
There is no default password.
If this is blank and AUTOLOGIN_ENABLE is configured
to USE_AUTOLOGIN_ID in the device configuration
file, the IP Deskphone does not log on.
Configure the provisioning server
92 SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012
Comments? [e-mail]