User's Manual

- YES –– the IP Deskphone uses private DSCP values,
unless overridden.
- NO –– the IP Deskphone uses either one of the configured
DSCP values or the system default values.
DSCP_CONTROL [x] This parameter uses a value entered in decimal format
between -1 and 63. If the value is -1, the DSCP
value is picked
up by the Service Package. The default value is 40.
- x –– a value from -1 to 63 indicating the DSCP value.
802.1P_CONTROL [x] This parameter uses a value entered in decimal format
between -1 and 7 representing the 802.1P value in the SIP
signaling packets. If the value is -1, the 802.1P value is
retrieved from the Service Package. The default value is 6.
- x –– the value from -1 to 7 indicating the 802.1P value.
DSCP_MEDIA [x] This parameter uses a value entered in decimal format
between -1 and 63 representing the DSCP value in the
Real-time Transfer Protocol packets. If the value is -1,
the DSCP value is retrieved from the Service Package.
The default value is 44.
- x –– a value from -1 to 63 indicating the DSCP
value.
802.1P_MEDIA [x] This parameter uses a value entered in decimal format
between -1 and 7 representing the 802.1P value in the
IP Deskphone Media (RTP) packets. If the value is -1
then the 802.1P value is retrieved from the Service
Package is the 802.1 setting for media Real-time
Transport Protocol (RTP). The default value is -1.
- x ––a value from -1 to 7 indicating the 802.1P
value.
DSCP_DATA [x] This parameter uses a value entered in decimal format
between -1 and 63 representing the DSCP value in the
provisioning packets. If the value is -1, the DSCP value
is retrieved from the Service Package. The default
value is 40.
- x ––a value from -1 to 63 indicating the DSCP
value.
802.1P_DATA [x] This parameter uses a value entered in decimal format
between -1 and 7 representing the 802.1P value in the
provisioning packets. If the value is -1, the 802.1P
QoS and ToS commands
SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012 83