User's Manual

exist. When a user creates a new profile the default
behavior is taken from this setting. After the creation
of a new profile this configuration setting is not used.
The default option is PUBLIC.
SCA_LINE_SEIZE_EXPIRES
[timeout]
This parameter allows the administrator to specify
expiration time in seconds for line-seize subscriptions
(Single Call
Appearance).
Allowed values are from 10 to 30 seconds. The default
value is 15 seconds.
— timeout - expiration time for line-seize subscriptions
in seconds.
RTP_MIN_PORT [x] The minimum RTP port value is an integer between
1024 and 65535, exclusive of the restricted SIP ports
between 5059 and 5080. The default value is 50000.
RTP_MAX_PORT [x] The maximum RTP port value is an integer between
1024 and 65535, exclusive of the restricted SIP ports
between 5059 and 5080. The default value is 50100.
Note:
The RTP port configuration parameters must satisfy
the constraints that (RTP_MAX_PORT -
RTP_MIN_PORT) is greater than or equal to 10 and
less than 1000.
Note:
If there is a provisioning error, RTP_MIN_PORT is
reset to the default value of 50000 and
RTP_MAX_PORT is reset to the default value of
50100. An error message is logged. The
SystemConfig file stores 50000 and 50100, rather
than the erroneous configuration values, to indicate
that the configuration attempt has been rejected.
CALL_WAITING [SPEAKER |
STREAM]
- SPEAKER – the call waiting tone is played on the
IP
Deskphone speaker. This is the default option.
- STREAM – the call waiting tone is injected into the
stream played on the transducer in use for the active
call.
DISTINCTIVE_RINGING [YES | NO] This feature works with the CS 2000 proxy.
- YES– turns on the distinctive ringing feature. This is
the default option.
- NO – turns off the distinctive ringing feature.
Feature configuration commands
SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012 49