User's Manual

Note:

Note 1: The SFTP file read and write pattern entries must be strictly followed.

The following are examples of valid and invalid formats of SRTP read and write patterns.

Example of valid formats:

SFTP_READ_PATTERNS: cfg,.rel,.re2,.re3,.dat SFTP_WRITE_PATTERNS:

cfg,.txt,.wr1,.wr2

Example of an invalid format:

.cfg, .txt

For the SFTP file read and write pattern entries to be valid, there must be no space between

the extensions.

Note:

Note 2: SFTP

writes can only be made to the sftpWr folder. You are only allowed to write a file

that is 10%, or less, of the available space on the folder.

If a file size greater than 10% is written, a write failure occurs, and the system logs the following

event:

1042[Minor][TUE JAN 02 19:08:18 2007][353][i:/fw/build/../util/

sshapp/sftpS erver.c:691] - File (./sftpWr/lf.wrl) too large to

write.

Note:

Note 3: If logon failures occur for SSH and SFTP

applications, the system logs the following

event:

1040[Minor][TUE JAN 02 20:12:14 2007][4189][i:/fw/build/../sshapp/

sshServer .c:616] - SSH Authentication Failed.

Manually configure the IP Deskphone for UDP and TCP

After you enable the administration user interface, you can manually change network settings

on the IP

Deskphone. You can manually configure the IP Deskphone through the Server

Settings menu.

Note:

o meet security requirements, the local administration user interface of the IP Deskphone

can be disabled for deployed IP Deskphones. If this is the case then you must manually

configure the parameters during initial IP Deskphone configuration or through the

provisioning server.

TCP/TLS operation overview

SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012 209