User's Manual

Convert SIP Software to UNIStim Software

The IP

Deskphone can be ordered with UNIStim software installed or with SIP software

installed. If you have an IP Deskphone with UNIStim software, and you convert the software

from UNIStim to SIP, the UNIStim software is overwritten. To convert an IP Deskphone from

SIP software to UNIStim software, a software reload is required.

Reloading UNIStim software

1. Determine the appropriate UNIStim version to match the hardware release number

of your IP Deskphone.

There are different versions of UNIStim software available for download. Which

version you choose depends on the hardware release number of your particular

IP Deskphone.

If the hardware release number of your IP Deskphone is among the following

hardware release numbers, download UNIStim software version release 0625C39

or higher (the hardware release number is the Product Engineering Code [PEC]

followed by the release number):

• NTYS05ACE6 20

• NTYS05BCE6 20

• NTYS05BCGSE6 04

If the hardware release number of your IP Deskphone is not among the previous

list, download UNIStim version release 0625C23 or higher.

Note:

UNIStim software version names contain numbers and letters. Use the last three

characters in a version to determine the minimum required version for the

conversion. For example, C39 is greater than C23.

Download the appropriate UNIStim software file to your provisioning server.

3. Create an 1xxxeSIP.cfg file containing the following information:

[FW]

DOWNLOAD_MODE FORCED

VERSION xxx

FILENAME yyy.bin

Convert SIP Software to UNIStim Software

SIP Software for Avaya 1100 Series IP Deskphones-Administration November 2012 115