User's Manual

80 Software requirements

If a firewall is installed on your DAP Controller PC, ensure the firewall

does not block the ports used for various services. For information,

see “Firewall protection” (page 80).

•

Internet Explorer 6.0 or later

• Internet Information Services (IIS)

For information about installing IIS, see “Internet information services”

(page 80).

•

DHCP and TFTP servers

For information about installing DHCP and TFTP servers, see “DHCP

and TFTP servers” (page 87).

•

DAP Controller (IP DECT Configurator and DAP Manager)

For information about installing the DAP Controller, see “DAP

Controller” (page 102).

Firewall protection

Both Windows XP Professional and Windows 2003 Server have built-in

firewalls.

By default, the firewall under Windows XP Professional does not allow

incoming access. However, the IP DECT Configurator can automatically

change the firewall settings. Verify the firewall settings after installation.

If a third-party firewall program is installed on your DAP Controller PC,

ensure the firewall does not block the ports used for the SIP DECT

system. By default, some ports are defined in IP DECT Configurator.

The ports defined by default:

•

From 3000 to 22229--multicast

•

From 28000 to 28017--DAP Controller services

•

30160--CDA services

If you change default ports in the IP DECT Configurator, ensure that the

firewall settings are updated correctly.

Internet information services

The DAP controller or manager runs as a service under Windows.

Because the management interface is available through a Web interface,

you must install the Web Server IIS.

Nortel Communication Server 1000

SIP DECT Fundamentals

NN43120-123 02.02 30 March 2010