User's Manual

System deployment 49

Figure 19

Example of a cell center

Mark the cell boundary.

Procedure 7

Demarcating a cell boundary

Step Action

1 Set up the deployment tool basestation at the cell center.

2 Enter the site survey mode on the handset.

For more information, see Procedure 1 “Entering the site survey

mode” (page 41) if you use Deployment Kit 2, or Procedure

149 “Entering the monitor mode” (page 270) if you use an older

Deployment tool.

3 See the floor plan and check audio quality in user offices

within the cell. If a user office is in a zone where audio quality

deteriorates, relocate the cell center closer to the critical point or

the office.

4 Walk into all the areas (rooms) necessary to mark the complete

cell boundary. Radio signals travel further in uncluttered areas

than in cluttered areas. Record the cell boundary.

5 Find the cell boundary by measuring the range and marking it

on the floor plan with a small x. Repeat steps Step 3 and Step

Nortel Communication Server 1000

SIP DECT Fundamentals

NN43120-123 02.02 30 March 2010