User's Manual

48 Site planning and hardware deployment

Procedure 6

Locating the cell center

Step Action

1 Place the deployment tool at one critical point and then use the

deployment handset to obtain a change in audio quality. The

audio quality change determines the cell boundary contour.

2 Repeat step 1 at an adjacent critical point. The call center is

where the cell boundaries of both critical points meet. Mark the

cell center position on a floor plan.

3 Use the cell contours to locate a cell center.

Locate the cell center where the cell contours meet. Choose a

position on the floor plan that meets the following requirements:

•

is farthest from the critical points

• provides good audio quality at the critical point,

• complies with the requirements described in section

“Deployment requirements” (page 18)

•

is in the coverage area

Label the cell center on the floor plan with the following symbol.

xCn, where x = the floor and n = is the cell number in sequence

of the entire plan.

In Figure 19 "Example of a cell center" (page 49), IC1 is a cell

center.

--End--

Nortel Communication Server 1000

SIP DECT Fundamentals

NN43120-123 02.02 30 March 2010