User's Manual

Troubleshooting 239
If you use the MS Windows TFTP Server, ensure
•
Run TFTP Server on this PC is selected
• Windows TFTP Server on this PC is selected
•
Microsoft windows TFTP Server (Trivial FTP daemon) is running
• dapcfg.txt and DAP firmware package are presented in the
C:\TFTPDROOT folder
If you use a built-in DHCP Server, ensure
• Run DHCP Server on this PC is selected
• the DAP IP range is entered
•
the DAP IP Range exclusive for DAPs only is selected
• the Subnet Mask is entered
• the Default gateway is entered
•
the TFTP IP address (of the DAP Controller PC) is entered
•
the DHCP Server is running (Activate / Deactivate / System status
button)
If you use built-in TFTP Server (IP DECT Configurator), ensure
• Run TFTP Server on this PC is selected
•
3com TFTP Server on this PC is selected
•
TFTP Server is running (Activate / Deactivate / System status button)
For more information, see “DHCP and TFTP servers” (page 87).
If you cannot make calls from a DECT handset to an IP/TDM telephone
on the call server (SIPN Configuration)
Prerequisites
•
The signaling server, call server, and DECT system are configured and
connected to the Ethernet.
• The DAPs are working.
If you cannot dial an IP/TDM telephone on the call server, verify the
following:
• Ensure that a dial tone sounds if a handset goes off-hook
• Ensure that the DECT handset is subscribed. For more information,
see “DAP manager configuration” (page 120).
• For DAP Manager
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
.