User's Manual

17
.
Site planning and hardware
deployment
Navigation
•
“Components of SIP DECT systems” (page 17)
• “Deployment requirements” (page 18)
•
"Types of SIP DECT configuration" (page 28)
•
“Site planning” (page 32)
•
“System deployment” (page 38)
Components of SIP DECT systems
This section contains information about the following topics.
•
“Call server, Signaling server, and SIP Line Gateway” (page 17)
•
“PC (DAP controller)” (page 18)
•
“DECT Access Points” (page 18)
Call server, Signaling server, and SIP Line Gateway
Before you install SIP DECT you must install and configure a CS 1000
system, as follows:
• For SIPN configuration, install Call Server and Signaling Server.
• For SIPL configuration, install Call Server and SIP Line Gateway.
For more information about SIP Line Gateway, see SIP Line Fundamentals
(NN43001-508).
CS 1000 Release 6.0 introduces the CP PM Co-resident Call Server
and Signaling Server (CP PM Co-res CS and SS), which can run the
Call Server software, the Signaling Server software, and the System
Management software on the same hardware platform operating under
the RedHat Linux operating system.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
.