User's Manual

Multi site mobility network configuration 157
Configuration of UEXT on the remote system
You must configure Universal Extension (UEXT) for multiple-site handset
DNs, for example, 5010, on the remote system to redirect incoming calls to
the DAP. Key 0 corresponds with the multiple-site handset DN configured
on the DAP. Key 1 HOT P is the same number with access and location
codes for UDP, or trunk steering code for CDP, to access SIP trunks to the
DAP that is installed on the remote system.
Table 26
LD 11: Add universal extension for multiple-site DECT handsets (UDP)
Prompt Response Description
REQ NEW Add new extension
TYPE UEXT Universal Extension
CUST
n
n = customer number
TNI L s c u, for
example
960110
where L = virtual superloop, s = shelf,
c = card, u = unit
UXTY SIPN UEXT subtype
DES
aaaa
Designator. Optionally, enter a description.
KEY 0 aaa yyyy, for
example
0 SCR 5010
0 aaa yyyy = Primary UEXT DN:
• aaa = MCN, MCR, SCN, or SCR
•
yyyy = primary DN
1 HOT P nn yyyy,
for example
1 HOT P 8
93325010
1 hot p nn yyyy = Target DN:
• nn = DN length (maximum length is 32)
•
yyyy = <AC1+LOC+ subscribed DN on DAP>
Table 27
LD 11: Add universal extension for multiple-site DECT handsets (CDP)
Prompt Response Description
REQ NEW Add new extension
TYPE UEXT Universal Extension
CUST
n
n = customer number
TN L s c u, for
example
960110
where L = virtual superloop, s = shelf
c = card, u = unit
UXTY SIPN UEXT subtype
DES
aaaa
Designator. Optionally, enter a description.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
.