User's Manual

In Figure 20: Example of a cell center on page
50, IC1 is a cell center.
Figure 20: Example of a cell center
Use the following procedure to mark the cell boundary
.
Demarcating a cell boundary
1. Set up the deployment tool basestation at the cell center.
2. Enter the site survey mode on the handset.
For more information, see
Entering the site survey mode on page
43 if you use
Deployment Kit 2, or
Entering the monitor mode on page
213 if you use an older
Deployment tool.
3. See the floor plan and check audio quality in user offices within the cell. If a user
office is in a zone where audio quality deteriorates, relocate the cell center closer
to the critical point or the office.
4. Walk into all the areas (rooms) necessary to mark the complete cell boundary. Radio
signals travel further in uncluttered areas than in cluttered areas. Record the cell
boundary.
5. Find the cell boundary by measuring the range and marking it on the floor plan with
a small x. Repeat steps
3 on page 50 and 4 on page 50 until there you have sufficient
Xs so you can draw a contour arc around the cell center.
For an example of a cell boundary, see Figure 21: Example of a cell center
boundary on page
51.
Site planning and hardware deployment
50 SIP DECT Fundamentals October 2012
Comments? [e-mail]