User's Manual

5. Snap the cover of the C4710E DAP to the rear side, to close the DAP cabinet.
Fasten the cabinet by mounting the two screws into the two holes in the rear side
of the cabinet.
6. Unlock the cabinet, and open the cabinet door.
7. Remove the foam cover and foam blocks from the cabinet.
8. Mount the swivel, and route the incoming cable through the swivel.
9. Verify that the cable fits snugly into the waterproof inlet housing.
10. Connect the incoming cable to the connection box that is delivered with the outdoor
cabinet.
11. Connect the CAT5 cable that is inside the outdoor cabinet to the connector box.
Installing a C4710E DAP in an external housing with an external antenna
SIP DECT Fundamentals October 2012 231