User's Manual

Figure 65: Mounting the cabinet to the wall
1
1. Push the special nuts that came with the cabinet into the corner holes of the
cabinet.
Figure 66: Pushing the special nuts in place in the corners of the cabinet
12. Lead the cable via the swivel into the cabinet.
Note:
The cable length in the cabinet must be 20 cm (this includes the RJ45 connector
which you must mount to the cable later).
Note:
At the outside of the box, the cable must lead directly from the cabinet into the
building to avoid exposing the cable to lightning.
13.
Tighten the cable inlet on the swivel and make sure that the cable inlet is
waterproof.
14. Lead the cable to the 4720 DAP and mount the RJ45 connector to it using the tool
for mounting an RJ45 connector plug to a Category 5 cable. For more information
on standard color schemes, see
Wire color coding for Category 5 cables on page
27
Install the external housing
220 SIP DECT Fundamentals October 2012
Comments? [e-mail]