User's Manual

3. Select the DAP to edit.
4.
Click Edit.
5. Enter the new RPN.
The RPN must be a hexadecimal two-digit number in the range 000 to 00F.
6. Click OK.
Wait until DAP restarts and starts working.
Restarting a DAP
Follow this procedure to restart a DAP
. This can be required if you are upgrading software, or
if a DAP is not functioning properly.
Restarting a DAP
1. Open Internet Explorer and enter the following URL in the address field: localhost/
cds.
The DAP manager IP DECT page appears.
2. Click Access points.
The DECT Access Points page appears.
3. Select the DAP to restart.
4. Click Reboot.
The DAP restarts. It takes several minutes for the DAP to begin working again after
it restarts.
System administration
130 SIP DECT Fundamentals October 2012
Comments? [e-mail]