User's Manual

Branch Office configuration supports seamless handover within each branch office, but not
between sites. Support is unavailable for roaming between branch offices.
To configure Branch Office, see Basic (simple) SIP DECT configuration with Communication
Server 1000 SIP Line Gateway on page 93
. Use the information in this section when you
require information about Branch Office configuration.
Use the following procedure to select a Branch Office configuration.
Selecting a system configuration
1. Perform one of the following steps:
If you were referred to this section from
Configuring System Settings on page 96,
go to step 3.
OR
Open the IP DECT Configurator, and click Modify.
2. Select the SIP DECT system that you are running, and click System
Configuration.
3. Choose Main Site with Branch Office(s) for System configuration, as shown in
the following figure.
System configuration
108 SIP DECT Fundamentals October 2012
Comments? [e-mail]