Configuration Guide

44 Chapter 4 Configuring the R2MFC MBM
N0027684 01
End of dialing (outgoing)
End of dialing in outgoing calls is indicated by MFC signal “I15” (or equivalent country-specific
signal). This signal is sent if the far-end requests next digit beyond the last digit of the dialed
number.
When R2MFC MBM originates a call to the CO, the R2MFC MBM has already received the
whole dialed number from the BCM. This is because the digits are passed from BCM to the MBM
by PRI “en-bloc.” This operation mode means that BCM determines user end-of-dialing either by
number of digits, explicit input from user (for example, the “#” digit), or timeout.
Disable ANI
The ANI request option can be disabled. When disabled:
• Incoming call — R2MFC MBM does not request ANI.
• Outgoing call — When far end requests ANI, R2MFC MBM answers “ANI not available.”
Default category
The MFC subscriber category, sent by R2MFC MBM in outgoing calls, is fixed. The default
category for all countries is II1 (subscriber without priority). If needed, the default can be changed
by CLI.
Default subscriber status
The user can set default subscriber status (for example, free, busy, and vacant number) for
incoming calls. When this feature is enabled, the R2MFC MBM in an incoming call sends the
preset default subscriber status, instead of the status received from the PRI status.
The subscriber status option is not enabled in R2MFC MBM; therefore, the subscriber status is
translated from ISDN message to MFC, and vice versa.
Minimum (or fixed) number
length and timer
Minimal number of digits Receiving minimum number of
digits + optional number of
digits means end of dial
(maximum length reached)
When a fixed length number is
always expected, set the
optional number of digits to 0.
No
Minimum (or fixed) number
length and timer
Optional number of additional
digits
No
Minimum (or fixed) number
length and timer
Interdigit timer in the minimal
interval (long timer)
Expiry of the long timer means
MFC error - number
incomplete.
No
Minimum (or fixed) number
length and timer
Interdigit timer in the optional
interval (short timer)
Expiry of the short timer
means end of dial.
No
Table 2 Minimum (or fixed) number length + timer parameters (Sheet 2 of 2)
Option Parameters Meaning Default