Configuration Guide

32 Chapter 3 Installing the R2MFC MBM
N0027684 01
1 If you are adding or replacing an R2MFC MBM in an active system, perform the following
steps:
a Access the Unified Manager.
b Choose System.
c Select the Logoff menu and then click Shutdown.
d Click Yes .
e Wait until the Status changes to Complete! It is safe to turn off the system.
f Click Done.
g Exit the Unified Manager.
2 Attach one end of the grounding strap to your wrist and the other end to a grounded metal
surface.
3 Ensure the cables connected to the front of the BCM and the expansion unit are clearly marked
as to how they are connected.
4 Disconnect the BCM and expansion unit power cords from the AC outlet.
5 Remove the cables from all the R2MFC MBMs and the media services card (MSC) on the
BCM base function tray and the expansion unit (if attached).
Installing an R2MFC MBM
Follow the procedures in this section to install an R2MFC MBM in a BCM platform base chassis
or expansion unit.
Installing an R2MFC MBM in the BCM platform base chassis
Perform the following steps to install an R2MFC MBM in the BCM platform base chassis:
1 Ensure that both the faceplate and underside DIP switches on the R2MFC MBM are set
correctly. For information on how to set the faceplate switches, refer to “Setting Config DIP
Warning: Failure to follow procedures to properly disconnect the BCM and
expansion unit can result in module or system damage.
Warning: Ensure you are properly grounded before handling modules or any
components that are part of the BCM hardware.
Caution: Only install the R2MFC MBM when the system is powered down. See
“Shutting down the system” on page 31.