Administrator's Guide

Trunk Group
Issue 5 October 2002 1237555-233-506
Busy Threshold
Use this field if you want attendants to control access to outgoing and two-way
trunk groups during periods of high use. When the threshold is reached and the
warning lamp for that trunk group lights, the attendant can activate trunk group
control: internal callers who dial out using a trunk access code will be connected
to the attendant, and the attendant can prioritize outgoing calls for the last
remaining trunks. Calls handled by AAR and ARS route patterns go out normally.
Call Still Held
This field appears if the Group Type field is co or fx. This field is used when the
receiving switch initiates the disconnection of incoming calls. It effectively
extends the Incoming Glare Guard timer by 140 seconds. This field affects only
TN438B, TN465B, and TN2147 ports and is used primarily when the Country
Code field is
2.
Valid entries Usage
1
to 99
(
DEFINITY SI,
CSI)
Enter the number of trunks that must be busy in order to
light the warning lamp on the Attendant Console. For
example, if there are 30 trunks in the group and you
want to alert the attendant whenever 25 or more are in
use, enter
25.
1 to 255
(DEFINITY R,
S8700
IP-Connect)
Valid entries Usage
y/n
Enter y to prevent glare by delaying an outgoing seizure of a
trunk for at least 140 seconds after it is released from an
incoming call.