User's Manual
Configuring SNMP options in Network Management
Issue 1 June 2010 27
7. Click Add.
The system displays the Add Trap Destination page.
8. On the Add Trap Destination page, do the following:
a. Ensure the check box for Check to enable this destination is selected.
b. Enter the IP address of the management station, and then do one of the following:
- Check the SNMP version 1 option, and enter the community name.
- Check the SNMP version 2c option, ensure notification type is trap, and enter the
community name.
- Check the SNMP version 3 option, ensure notification type is trap, and enter the
user name and password.
c. Click Add.
9. Click Firewall in the left panel.
The system displays the Firewall page.
10. On the Firewall page, do the following:
a. Click Advanced Setting.
b. Ensure the input and output check boxes for port 161 and port 162 are selected.
c. Click Submit.
11. Open the Network Management Console application.
12. Select File > Options.
13. Select the CM Servers Passwords tab.
14. Enter the IP address, user name, and password for each Avaya Aura™ Communication
Manager server.
15. Select the SNMP Access tab.
16. Set up the SNMP rule for the Communication Manager server IP addresses.
Note:
Note: The SNMP time-out value must be set to 60 seconds (60000), and the retries
value must be set to 1.
17. Run Network Discovery. For information, see Discovering the Voice Network
on page 35.
Configuring SNMP options in Network Management
The Avaya Network Management Console must be configured with SNMP parameters in order
to successfully discover and communicate with devices in your network. SNMPv1 uses